Warning – BabyTrend 7548LX-PT - SIT N' STAND PLUS STROLLE - SILVERADO User Manual

Page 5

Advertising
background image

WARNING:

Avoid serious injury from

falling or sliding out. Always use the seat belt.

TO SECURE FRONT/REAR SITTING CHILDREN

1 The shoulder straps of the 5-point harness has 2 attachment positions.

Select the loop position that places the shoulder strap level with, or below

the top of the childʼs shoulder and feed the shoulder harness under the

correct loop. Please see figure 10.

2. Carefully place the child in the stroller seat and bring the safety harness

around the childʼs waist and over the shoulders. Place the crotch strap

and between the childʼs legs. Insert the male end of each shoulder / waist

belt into the buckle on the crotch strap. Tighten the harness to be snug

around the childʼs waist and over the childʼs shoulders. Please see figure

11.

3. To release, apply pressure to both sides of each male clip until the clip

is released. This process requires a moderate amount of effort so as to

prevent an accidental release by your child. NOTE: Buckles may be hard

to release when 1st used.

1. The rear platform and jump seat are designed to accommodate a child

who is at least 2 1/2 years old, has good balance and coordination, and is

not over 40 inches tall. Position the child on the platform on the back of

the stroller. Be sure child is facing forward and hands are holding frame.

Secure the safety belt behind child and engage buckle. See figure 12.

2. Be sure that the childʼs feet are fully on the platform at all times.

PLEASE NOTE: When using the rear SEAT you must put the STAND

FEATURE SAFETY BELT in the storage location located on the rear of

the seat. Please See Fig. 12A

WARNING:

To avoid a possible

choking hazzard when using the rear seat, put

the STAND FEATURE SAFETY BELT in the

storage location on the rear of the seat.

I

TO SECURE REAR STANDING CHILD

TO SECURE CHILD

Fig. 11.

Fig. 12.

Shoulder Strap

Squeeze

Crotch Strap

Waist

Strap

Adjust for a

snug fit

Fig. 10.

5

1. Have child sit on the jump seat facing backwards. Secure the seat belt,

which is attached to the back of the seat, around the childʼs waist, and

buckle to the crotch strap. See figure 12B. Adjust the seat belt to be snug

around the childʼs waist.

2. To release, apply pressure to both sides of the male clip until the clip

is released. This process requires a moderate amount of effort so as to

prevent an accidental release by your child.

3. Be sure that the childʼs feet are fully on the platform at all times.

TO USE JUMP SEAT

Fig. 12A.

Fig. 12B.

Advertising