BabyTrend HC01983 - TREND HIGH CHAIR - ALL STAR - Manual (Page 6)

Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved. Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
OPERATION MAINTENANCE
9 10
6-position
WARNING:
Do not adjust
seat height with child in seat.
Adjust seat height before placing
your child in the high chair.
TO ADJUST SEAT HEIGHT
Squeeze both left and right lever of the Height
Adjustment Bracket and adjust to the ideal
position. (Fig. 22)
WARNING:
Always check
that the height adjustment bracket
is level and both left and right sides
locked before placing child in the
high chair.
TO FOLD HIGH CHAIR
The High Chair may be folded with the seat in any
of the height positions. The high chair will be the
most compact with the seat in the lowest position.
1. Place seat in the desired height position (Fig. 23).
2. Place Seat Back in the most upright position
(Fig. 19).
3. Squeeze the tray release handle and slide the
tray out. (Fig. 17) Hang the tray on the hooks
located on the back of the rear leg. (Fig. 23)
4. Pull upward on the release levers (located on
the sides of the frame) and push the rear legs
in the direction of the front legs until folded.
(Fig. 24) Chair is now ready to put away.
DO NOT allow your child to play around a
folded high chair as it may fall.
TO UNFOLD HIGH CHAIR
Push the legs apart until fully open and locked.
Push downward on the fold levers (left and right)
to ensure the frame is locked. (Fig. 16)
CARE AND MAINTENANCE
WARNING:
Harness Straps and Basket are NOT washable.
Dishwasher Safe Tray Insert
The Tray Insert is dishwasher safe to 160 degrees Fahrenheit. Do not use scouring pads
on the Tray Insert as they will damage the surface and the Tray Insert will become more
difficult to clean.
High Chair/Tray
Clean High Chair and Tray after each use using mild household dish soap. Please use only
a soft bristle brush, sponge or cloth to clean the surface or remove particles of food.
DO NOT submerge High Chair and Tray in water. Surface clean only.
Seat Pad (please refer to care label on the seat pad for cleaning instructions)
To remove the seat pad:
Remove Harness Straps by pushing Harness Attachment Tabs through the Harness slots on
the Seat Back, Seat Base, and Seat Pad. Remove Elastic Loops from Attachment Tabs on
Seat Base and Seat Back.
None-Washable Seat Pad:
Please use sponge or cloth with mild household detergents to surface clean the seat
pad. DO NOT MACHINE WASH the seat pad.
Washable Seat Pad:
Machine Wash COLD DELICATE CYCLE with non-chorine based Laundry
Detergent. DO NOT USE BLEACH. HANG DRY. DO NOT MACHINE DRY.
Basket
NOTE: Certain Models will have a Basket underneath the seat for storage. These Models
will be packaged with the Basket already attached to the Seat Base.
To remove:
The Basket is attached by four snaps. Release these snaps for removal.
To attach:
Feed snap strips around Basket Slots underneath Seat Base. Press firmly on the four snaps.
Fig. 22
Fig. 23
Fig. 24
Fig. 25
TO ATTACH OR REMOVE TOY
TO ATTACH OR REMOVE MUSIC TOY
The Music Toy (Part # 16) is attached through the
suction cup on the bottom of the Toy. To attach
simply press the Toy on the Tray, to remove lift up
a part of the bottom of the cup.
TO ATTACH OR REMOVE TEETHING TOY
Press the Teething Toy (Part # 17) connector into
the curved slot in Tray edge and snap bottom
of connector over lower lip of Tray. Reverse to
remove the Toy (Fig. 25).