Pace-Edwards BL Ford Ranger - Manual (Page 5)

5 INSTALLATION INSTRUCTIONS
STEP 6: INSTALLING CLAMPS
HARDWARE USED: Before shimming and installing the rail clamps make sure the canister is centered between
the truck bed rails.
Slide the front adjustable clamp shims (Figure 5A) down the rails 6-12” from the canister.
Place the plastic shim along the truck bed rail as shown in Figure 5A to shim up the
Adjustable Clamp Shim Bracket.
Loosen the bolt on the front clamp shim and slide the bracket up against the truck bed
rail and plastic shim. Then tighten the bolt so the clamp shim is held tight in place. (Figure
5A).
Slide the front clamp rail grips (Figure 5B) 1” from the adjustable clamp shim on both the
left and right side rails.
Slide the rear adjustable clamp shims (Figure 5A) down the rails 6-12” from the tailgate.
Place the plastic shim along the truck bed rail as shown in Figure 5A to shim up the
Adjustable Clamp Shim Bracket.
Loosen the bolt on the rear clamp shim and slide the bracket up against the truck bed rail
and plastic shim. Then tighten the bolt so the clamp shim is held tight in place. (Fig. 5A).
Slide rear clamp rail grips 1” from the adjustable clamp shim on both the left and right
rails.
Assemble the pivot arms to the clamp rail grips and snug the bolts on the clamps so that the
rails rest fi rmly against the truck bed. (Figure 5B) Close the tailgate and position the rails
with a 1/16” gap from the tailgate.
Make sure the between the rails measurement is 53-5/16” at both the canister and tailgate.
This distance should be the same (53-5/16 inches) at both the canister and tailgate ends of
the rails to allow your cover to operate properly.
Once everything is square tighten the rail clamps completely.
DO NOT TIGHTEN OVER 120-INCH POUNDS!
Inside of
Truck Bed
Pivot Arm
Clamp Bolt
(tighten for
proper fi t)
Clamp
Rail Grip
Rail
Adjustable Clamp
Shim Bracket for
both front a& rear
Adjusting
Bolt
Plastic
Shims
FIG. 5A
FIG. 5C
ADJUSTABLE CLAMP SHIM
ASSEMBLY x 4
PLASTIC SHIM x 4
RAIL SPEED CLAMP
ASSEMBLY x 4
FIG. 5B
Inside of
Truck Bed
Rail