Peterson AutoStrobe 590 - Manual (Page 11)

Page 9
+
7
÷
DOWN
UP
OFF
ON
Increment
Decrement
DOWN
UP
KEY= C
A=440 C 00 ¢
AUTO
SETUP MODE MET
1 2 3 4
1
SETUP MENU
PLEASE SELECT MODE
OPTN FILE RUN DIAG
1 2 3 4
Accessing the Setup Screen
b) VIEWING AND MODIFYING PARAMETER DEFAULTS
The "OPTN" or Option selection provides further menu screens, each of which is dedicated to viewing and/or altering a given
SETUP parameter. The SETUP parameters, their valid ranges, and the buttons used to alter them are summarized below:
SCREEN PARAMETER SETTING VALID RANGE: BUTTONS:
RUN (before
entering SETUP) Strobe Disc Band
DISPLAY +2 / -1 +2, -1, Normal, ...
Factory Default: Normal
DISPLAY
+2
—
-1
1st SETUP
parameter screen Concert A Pitch Reference
Recalibration
350 Hz to 550 Hz in 1 Hz
increments
Factory Default: A=440
3
4
2nd SETUP
parameter screen
Musical KEY Setting
C, B=, F, E=, ...
Factory Default: KEY=C
KEY
3rd SETUP
parameter screen Auto-Note Selection Mode
Setting OFF, ON
Factory Default: ON
3
4
4th SETUP
parameter screen Metronome
BEATS/MINute Rate 40 TO 240
Factory Default: 120
8
9
4th SETUP
parameter screen Metronome
BEATS/MEASure Length 1 TO 8
Factory Default: 4
2
3
Each press of the "1" button (labeled "NEXT") will sequence through screens for each of these parameters except for the
Strobe DISPLAY +2/-1 parameter which does not have a SETUP screen. Except for the Concert A pitch reference
recalibration, these parameters can be altered more directly from the RUN screen. However, altering the power-up state of
these parameters can only be effected under SETUP.
L
L
L
L
L
L
L
L
L
L