Peterson VS-R StroboRack - Manual (Page 27)

27
StroboRack
™ SR-EX PRO Expander Module
INSTALLATION
Install the SR-EX PRO Expander according to the included instructions.
GENERAL
With the Expander installed, the StroboRack’s input, routing and patching possibilities are vastly increased, but the operation of the tuner remains the same as do all
front panel functions and procedures.
SIGNAL ROUTING
The rear panel combo (¼” Stereo/XLR) input recognizes automatically whether a ¼” mono, ¼” stereo or XLR type plug is inserted and routes the signal as follows:
¼” mono input to Output 1.
¼“ stereo input to Output 1 (Tip) & Output 2 (sleeve). (Either of these inputs can be patched to the DI Input if required)
XLR input to XLR Output, the StroboRack SR-EX features high quality THAT Corporation’s OutSmart
™ balanced line receivers and drivers for optimal sound quality.
(Note: With the SR-EX Expander installed, the front panel mono input is sent to Outputs 1 only).
DI INPUT JACK
This can be used to patch Output 1 or 2 to the built-in active DI, or alternatively as a completely independent DI for a separate instrument.
GROUND SWITCH
This switch controls the signal ground (NOT the electrical ground). The DI circuit features a switch, which allows the choice of Ground connected/Auto/Ground lifted.
Factory default position is AUTO, this means that the StroboRack detects whether or not there is already a ground present and switches automatically.
The StroboRack is one of the first audio products to feature auto-ground, but as other manufacturers incorporate it in the future, remember that in a system with
multiple rack units featuring Auto-ground, only one can be the master, otherwise, constant switching will occur, therefore disable Auto-Ground in all but one rack unit.
REMOTE FOOTSWITCH OPERATION (Dual footswitch 403087)
Use a Peterson dual latching footswitch pedal (Part# 403087) inserted into the Preset/Mute jack on the rear panel to remotely 1) advance the StroboRack’s presets
and 2) mute the StroboRack’s output signal for silent tuning.
Use a second Peterson dual footswitch pedal (Part# 403087) inserted into the Output Select jack on the rear panel to remotely activate and deactivate each of the
Expander’s dual mono outputs.
Remote dual footswitch pedal 403087 is available from your Peterson dealer or from
www.petersontuners.com .
Preset/Mute
Dual Footswitch
Input
Channel Select
Dual Footswitch
Input