Peerless-AV PC932C-W - Installation - Manual (Page 11)

11 of 35 ISSUED: 11-29-07 SHEET #: 202-9263-2 08-17-11
Adjusting Display
© 2011, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
NOTE: Be certain mount is in the desired
extended position.
Attach cables to display if routed through
channels.
Cut cable covers (G) to the length of inner
channel (C) and outer channel (B) openings,
leaving space for cables if routed through
channels. Snap cable covers into openings as
shown.
Cables not routed through channels will
require cable ties (not included).
Install Cable Covers
9
CUT TO
LENGTH OF
OPENING
G
CUT TO
LENGTH OF
OPENING
G
C
If screws indicated are fully tightened, loosen screws half a turn to allow for adjusting tilt, swivel and roll. Adjust
display to the desired position and fully tighten screws.
8
• Do not loosen adjustment screws to the point they become disengaged from the mount. Weight of the display
should be supported in case of accidental disengagement.
SCREWS FOR
ROLL ADJUSTMENT
SCREWS FOR
TILT ADJUSTMENT
(BOTH SIDES)
SCREWS FOR SWIVEL ADJUSTMENT
25° (+20°/-5°) TILT 90° (±45°) SWIVEL 6° (±3°) ROLL
R O L L A D J U S T M E N T
BACK VIEW
TILT A D J U S T M E N T
SIDE VIEW
SWIVEL A D J U S T M E N T
BOTTOM VIEW
B
SLOT ALLOWS FOR
INCREMENTAL TILT
ADJUSTMENTS OF 5°
WARNING