Peerless-AV ACC316 - Installation - Manual (Page 3)

ISSUED: 01-30-07 SHEET #: 009-9037-1
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
3 of 4
Select slot in tray according to diagram 5.1.
Remove backing and attach one clear strip (E)
through slot and around edge of tray as pictured
in diagram 5.2. Repeat for other slot in other side
of tray.
Note: This material prevents fraying or cutting of
the belt. Place electronic component onto tray.
Note: Be sure that front bottom edge of electronic
component is positioned behind and against the
front lip of the tray. This will prevent electronic
component from sliding forward on the tray.
Take one belt (C or D) and hold it so that the tri-bar belt clip (A) is facing as illustrated. Feed belt (C or D)
up through the slot you have chosen. Remember, belt only goes through outside slot. Now feed belt (C or
D) through belt clip (A) as shown. Repeat on other side of tray using other belt.
ELECTRONIC COMPONENT NOT SHOWN
C or D
A
TIGHTEN
E
DIAGRAM
5.2
DIAGRAM
5.1 BELT SLOTS
TRAY
ELECTRONIC COMPONENT NOT SHOWN
FRONT LIP
electronic component
ELECTRONIC COMPONENT NOT SHOWN