Caution – Peerless-AV SUA746H - Installation User Manual
Page 7
7 of 7
ISSUED: 05-01-12 SHEET #: 125-9307-1
Roll Adjustment
Cable Management
Adapter plate may be rolled +/- 5°. Roll locking screw may be tightened or loosened using 4 mm allen wrench (
G).
Cables may be routed using cable clip (
J).
Slip cable clip (
B) onto bottom of center joint as shown in figure 4.1 and secure cables to cable clip using cable tie
(
J) as shown in figure 4.2.
Secure cables to cable anchor (
I) using cable tie (J) as shown below.
3
4
JOINT SCReWS
ROLL LOCkINg SCReW
B
CeNTeR
JOINT
J
CABLeS
• Do not tighten joint screws. Doing so may cause
damage to screws, greatly reducing their holding
power.
CAUTION
I
J
CABLeS
© 2012, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
FIGURE 4.1
FIGURE 4.2