Peerless-AV HLG442-SB2848-SH-Q10 - Installation - Manual (Page 2)

2 of 4 ISSUED: 09-08-10 SHEET #:125-9142-4 09-15-11
Use swivel plate assembly ( A) as a template to mark location of holes, point 1 and point 2, approximately 6.5" apart
on table. Drill two holes using a 1/4'' drill bit.
Place two 1/4-20 x 1 3/4" elevator bolts ( C) into slots of swivel plate assembly (A).
SHOWN WITH 90° OF SWIVEL
AS AN EXAMPLE
F
A
2
POINT 1 POINT 2
TABLE TOP
6.5"
(165 mm)
1
C
Choose swivel range below and identify swivel
range holes of swivel plate assembly ( A).
Insert two M5 x 6 mm phillips type-F screws ( F) into
swivel range holes of swivel plate assembly ( A) as
shown below.
SWIVEL RANGE HOLE
Mounting using Bolt Down Method
90°
60°
A
60°
90° 30° 30°
FRONT
FRONT
A