Peerless-AV DS-VWC560 - Installation User Manual
Page 7
7 of 12
ISSUED: 03-08-11 SHEET #: 125-9195-5 09-20-12
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-865-2112.
6
Attach horizontal rails (
D) onto vertical supports (A) using sixteen 1/4-20 x 3.5" hex head screws (J), 1/4" SAE
washers [
6mm] (H) and 1/4-20 nylock nuts (K) as shown in detail 1. Make sure that horizontal rails (D) are level
then tighten all 1/4-20 x 3.5" hex head screws (
J). Place two tube caps (R) into tops of vertical supports (A)
as shown in detail 2.
NOTE: horizontal rails (D) must be secured using sixteen 1/4-20 x 3.5” hex head screws (J).
A
F
K
J
D
D
A
J
J
DETAIL 2
R
CABLE MANAGEMENT
7
Run display cables though top and bottom openings
in vertical supports (
A) as shown.
NOTE: Display cables can be covered using
18" mesh sleeve (
M) before securing.
Display cables can be secured to horizontal rails (
D)
using eight cable ties (
Q) as needed through slots in
horizontal rails (
D).
Q
DISPLAy CAbLES
M
D
bOTTOM
OPENING
TOP
OPENING
A
D
SLOT