Peerless-AV WL-ST660-200 - Installation - Manual (Page 9)

9 of 14 ISSUED: 08-24-12 SHEET #: 180-9038-2 10-30-12
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
MULTI-WASHER
SCREW
TILT BRACKET
(B or C)
fi g. 4.1
SPACER
Begin with longer length screw, hand thread through multi-washer, tilt bracket and spacer in that order into
display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three full turns into the display, select a shorter length screw from the
baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
4-1
Wireless Receiver Assembly and Power Module Assembly Setup
Remove the two #8 screws securing the cover of the wireless receiver assembly (G) as shown in detail 1. Open
the enclosure to expose the wireless receiver and IR receiver. Remove the M5 x 10mm phillips screws and open
the power module assembly (H) as shown in detail 2. 5
DETAIL 1 DETAIL 2
#8 SCREW
M5 X 10mm SCREWS
G
H