Peerless-AV DS-VWC655-3X3 - Installation User Manual
Page 7
7 of 13
ISSUED: 11-16-11 SHEET #: 125-9265-2 11-21-13
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-865-2112.
7
Attach three horizontal rails assemblies onto vertical supports (
A) using twenty-four 1/4-20 x 3.5" hex head screws
(
J), 1/4" SAE washers (F) and 1/4-20 nylock nuts (K) as shown in detail 2. Make sure that horizontal rail
assemblies are level then tighten all 1/4-20 x 3.5" hex head screws (
J). Place two tube caps (R) into tops of vertical
supports (
A) as shown in detail 2. NOTE: horizontal rails must be secured using twenty-four 1/4-20 x 3.5” hex head
screws (
J).
A
F
K
J
Y
A
J
J
DETAIL 2
R
CABLE MANAGEMENT
8
Run display cables though top and bottom
openings in vertical supports (
A) as shown.
NOTE: Display cables can be covered using
18" mesh sleeve (
M) before securing.
Display cables can be secured to horizontal
rails assemblies using cable ties (
Q) as needed
through slots in horizontal rails (
Y).
Q
DISPLAY CABLES
M
Y
BOTTOM
OPENING
TOP
OPENING
A
Y
SLOT