Peerless-AV WL-SA761PU-200 - Installation - Manual (Page 11)

11 of 23 ISSUED: 08-24-12 SHEET #: 180-9036-3 10-31-12
NOTE: Wireless Receiver and Power Box
removed for clarity.
Begin with the longest length screw, hand thread
screw through multi-washer, display brackets (B)
and spacer in that order into display as shown
below. Screw must make at least three full turns
into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three
full turns into the display, select a shorter length
screw from the baffl ed fastener pack. Repeat for
remaining mounting holes, level display brackets
and tighten screws.
6-1
6-2
DISPLAY
MULTI-WASHER
SPACER
B
SCREW
Center display brackets horizontally and
vertically on back of display. Tighten two 1/4-20
x 1.25" screws. Reinstall four 1/4-20 x .6" screws
using 5mm allen wrench (I) into appropriate
fi xed-stop position from chart on page 8.
1/4-20 x 1.25" SCREWS
1/4-20 x .6" SCREWS