Peerless-AV HLG440-RCA-Q10 - Installation - Manual (Page 4)

ISSUED: 06-29-11 SHEET #: 125-9220-4 07-31-12
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
4 of 6
Fig. 1.1
Note: Make sure that four corner 1/8" drilled holes are in the center of base tabs as shown in detail 1.
Place lock-down plate ( A) onto bottom of display base as shown. Use as a template to mark location of six
mounting holes. Drill six pilot holes using a 1/8'' drill bit into bottom of display base as shown in fig 1.1.
Note: Do not drill though display base.
1
PoINt 1 PoINt 2
tABLe toP
Use lock-down plate ( A) as a template to mark location of holes at point 1 and point 2, spaced 10.3" apart
on table. Drill two holes using a 9/32'' drill bit. Carriage bolts ( D) must be placed into slots as shown in
fig. 2.1 before mounting lock-down plate to display.
A
D
2
Fig. 2.1 Fig. 2.2
RCAJ42L750
10.3"
(261 mm)
SLotS
Drill six holes using a
1/8'' drill bit into bottom
of display base.
Six #10 X 3/8" undercut flathead self drilling screw ( C)
DetAIL 1
BASe tAB
1/8" DRILLeD HoLe