Peerless-AV IWB600-WB - Installation - Manual (Page 3)

3 of 7 ISSUED: 02-03-10 SHEET #: 125-9095-6 05-02-13
NOTE: Make sure fl ange of wall bracket is located on top as shown in detail 1
Be sure wall bracket (A) is level and in desired position. Then use wall bracket (A) as a template to mark center
of four mounting holes. Drill four mounting holes. Attach wall bracket (A) to mounting surface using four screws
provided by installer and four 1/4 washers (J) if required. Once secure, wall bracket (A) will be fl ush with the top of
the vertical bracket (D).
Fasten two M4 x 6 mm phillips screws (G) into ends of wall bracket (A) as shown in Detail 1.
NOTE: Vertical brackets (D) may be used to determine location of wall bracket (A).
1
A
J
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
WARNING
Screws provided by installer
Flange
A
TOP
Detail 1
G