Sena Bluetooth SPH10 v4.2 User's Guide - Manual (Page 30)

31
SPH10
English
19. RESET TO FACTORY DEFAULT
SETTINGS
1. To restore the SPH10 to factory default settings,
press and hold the Phone Button for 12 seconds
until the LED shows solid red and you hear double
beeps. You will hear a voice prompt saying
“Factory reset”.
2. Within 5 seconds, press the Jog Dial to confirm
reset. The headset will be restored to factory
setting and switched off automatically. You will
hear a voice prompt saying “Headset reset,
good-bye”.
3. If you don’t press the Jog Dial within 5 seconds,
the reset attempt is canceled and the headset
returns to stand-by mode. You will hear a voice
prompt saying, “Canceled”.
20. FAULT RESET
When the SPH10 is not working properly or is in faulty
status for any reason, you may reset by pushing the
pin-hole reset button at the back of the headset main
unit. Insert a paper clip into the reset pin-hole and
press the reset button for a second with light pressure.
The SPH10 will be switched off, and you have to turn
the system back on and try again. However, this will
not restore the headset to factory default settings.
21. FIRMWARE UPGRADE
The SPH10 supports firmware upgrade function.
Please visit Sena Bluetooth web site at www.
senabluetooth.com to check the latest software
downloads.