Features of your vehicle – KIA Forte_Forte5_Forte Koup 2014 User Manual
Page 116
4 47
Features of your vehicle
Erasing programmed Homelink
®
buttons
To erase the three programmed but-
tons (individual buttons cannot be
erased):
• Press and hold the left and center
buttons simultaneously, until the
indicator light begins to flash
(approximately 20 seconds).
Release both buttons. Do not hold
for longer than 30 seconds.
Homelink
®
is now in the train (or
learning) mode and can be pro-
grammed at any time.
Reprogramming a single
Homelink
®
button
To program a device to Homelink
®
using a Homelink
®
button previously
trained, follow these steps:
1. Press and hold the desired
Homelink
®
button. Do NOT release
until step 4 has been completed.
2. When the indicator light begins to
flash slowly (after 20 seconds),
position the hand-held transmitter
1 to 3 inches away from the
Homelink
®
surface.
3. Press and hold the hand-held
transmitter button (or press and
"cycle" - as described in
"Canadian Programming" above).
4. The Homelink
®
indicator light will
flash, first slowly and then rapidly.
When the indicator light begins to
flash rapidly, release both buttons.
The previous device has now been
erased and the new device can be
activated by pushing the Homelink
®
button that has just been pro-
grammed. This procedure will not
affect any other programmed
Homelink
®
buttons.
Gate operator programming &
canadian programming
During programming, your hand-held
transmitter may automatically stop
transmitting. Continue to press and
hold the Homelink
®
button (note
steps 2 through 4 in the
"Programming" portion of this text)
while you press and re-press
("cycle") your handheld transmitter
every two seconds until the frequen-
cy signal has been learned. The indi-
cator light will flash slowly and then
rapidly after several seconds upon
successful training.
OHD046306N
Flashing