KIA Forte_Forte5_Forte Koup 2010 User Manual

Page 96

Advertising
background image

4 31

Features of your vehicle

NOTICE

The following symptoms may occur dur-
ing normal vehicle operation:
• The EPS warning light does not illumi-

nate.

• The steering effort is high immediately

after turning the ignition switch on.
This happens as the system performs
the EPS system diagnostics. When the
diagnostics is completed, the steering
wheel will return to its normal condi-
tion.

• A click noise may be heard from the

EPS relay after the ignition switch is
turned to the ON or LOCK position.

• Motor noise may be heard when the

vehicle is at a stop or at a low driving
speed.

The steering effort can suddenly
increase, if the operation of the EPS
system is stopped to prevent serious
accidents when it detects malfunction
of the EPS system by self-diagnosis.

• The steering effort increases if the

steering wheel is rotated continuously
when the vehicle is not in motion.
However, after a few minutes, it will
return to its normal conditions.

• You may hear a noise while steering, in

very cold weather. It is a normal con-
dition.

D130300AFD

Tilt steering (if equipped)

Tilt steering allows you to adjust the
steering wheel before you drive. You can
also raise it to give your legs more room
when you exit and enter the vehicle.

The steering wheel should be positioned
so that it is comfortable for you to drive,
while permitting you to see the instru-
ment panel warning lights and gauges.

To change the steering wheel angle, pull
down the lock release lever (1), adjust
the steering wheel to the desired angle
(2) and height (if equipped) (3), then pull
up the lock-release lever to lock the
steering wheel in place. Be sure to adjust
the steering wheel to the desired position
before driving.

WARNING

• Never adjust the angle and height

of the steering wheel while driv-
ing.You may lose steering control
and cause severe personal injury,
death or accidents.

• After adjusting, push the steering

wheel both up and down to be
certain it is locked in position.

OTD049018

Advertising