GE P&W Sepa CF II Membrane Cell System - Manual (Page 2)

Page 2 FS1060EN
• Stainless steel body with Viton (Viton is a regis-
tered trademark of DuPont Dow Elastomers)
o-ring. Contributes to flexibility of use by allow-
ing almost any type of substance through the
membrane cell.
Typical Applications
• Acid Concentration
• Acid Purification
• Antibiotic Concentration
• Brackish Water Desalination
• Colloidal Silica Removal
• Dextrose Purification
• Dye Purification
• ED Paint
• Enzyme Concentration
• Fruit Juice Concentration
• Low Pressure Brackish Water Desalination
• Oil/Water Separations Organics Concentration
• RO/NF Pretreatment
• Sea Water Desalination
• Starch/Sugar Concentration
General Properties
Table 1: Operating Parameters/Connections
Pumps
Suggested lab-scale pumps include piston-driven
diaphragm that provides fewer pulsations. Contact
GE for further recommendations.
Fluid Transfer
Depending on pressure, standard tubing or hose
can be used for connecting cells to vessels. The
connection between the pump and inlet valve on
the cell should be a high-pressure hose. Contact GE
if additional help is required.
Compatible Flat Sheet Membranes
Accommodates any 7.5 in x 5.5 in (19 cm x 14 cm)
flat sheet membrane for a full 22 in
2 (140 cm 2 ) of
effective membrane area. (See Figure 3 which
shows assembling the cell membrane.)
GE offers precut and individually wrapped mem-
brane inserts in single or assortment packs from
our large selection of reverse osmosis, nanofiltra-
tion, and ultrafiltration membranes. Single packs
are available with the microfiltration membranes.
Figure 3: Assembling cell membrane
Packaging Information
Table 2: Materials of Construction/Dimensions
For more information
• Email: [email protected]
• Tel: 800-444-8212 USA
• Canada Tel: 952-988-6665
• Web: www.geosmolabstore.com