GE P&W Pleated Filters - Flotrex AP Pleated Filters - Manual (Page 2)

Page 2 FS1079EN Jan-09
Table 5: Flow Performance in Clean Water 1
1 Data based on 10” length filter
Table 6: Ordering Information
Additional Information
• Flotrex AP filters may be autoclaved or in situ
steam sterilized (up to 257°F [125°C], 30-minute
cycles) for a maximum accumulated exposure
of 10 hours. Alternately, the filters may be sani-
tized with compatible chemical agents.
• GE certifies that the material contained in its
Flotrex AP pleated filters meet U.S. FDA
requirements for food contact under the appli-
cable regulations in 21 CFR. For further informa-
tion, contact GE technical services. Flotrex AP
filters meet the test criteria for USP class VI-
121°C Plastics.
• Aqueous extracts from Flotrex AP filters contain
less that 0.25 EU/ml. The filters typically exhibit
low levels of non-volatile residues.
• GE filter cartridges are designed and manufac-
tured for resistance to a wide range of chemical
solutions. Conditions will vary with each appli-
cation and users should carefully verify chemi-
cal compatibility. Please contact your GE
distributor for more information.
• Table 6 provides additional ordering information.