Prokit's Industries FB-1688 - Manual (Page 5)

CAUTION
• Dust on the blade edge or clamp might cause loss
of cleaving performance or poor quality of fiber
end face.
• Do not clean them with any other kind of
chemicals.
• If the Clamp Cover is closed leaving an off-cut
fiber on the clamp, the rubber pad of clamp w
BLADE POSITION CHANGE
n a symptom that
fiber cannot be cleaved or cracks will occur. If such
symptom continues to appear, th
orn
out. Rotate the blade according t the following
procedures and use a new blade osition.
[Reference] approximately 1,000
1.
Loosen the blade set screw. (fig.1)
the blade to the next position by pressing its
n sw
ection indicated by the
ill
have a trace of fiber, causing loss of cleaving
performance or poor quality of fiber end face.
creases, As the number of the cleaving i
e blade position is w
o
p
fibers per position
2. Rotate
side or edge with cotto
Rotate the blade in the dir
arrow. (fig.2)
ab.
Fig.1 Fig.2
5