R&M Materials Handling MANUAL CHAIN HOISTS - Manual (Page 76)

RMLH / RMLHC INSTRUCTION
MANUAL/EN/07.20.10
4/9
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret
that may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
1 INSTALLATION
Check that:
The beam is adequate for the loads to be supported.
The beam flange dimensions correspond to the trolley to be installed.
The wheels will be able to travel freely along the rail.
All nuts are properly tightened and include the cotter pin.
The trolley wheels have adequate clearance along the entire length of rail.
The end stops are in place before operating.
1.1 Trolley Adjustment
Trolley models have a single flange width range. The trolley is adjustable only for that individual flange width
range. Table 1 on the following page indicates the beam flange range for each trolley model.
Figure 1. Trolley Adjustment