Technical data, Installation, 1 replacing the lamp – AEG SKS81040F0 User Manual
Page 29: 2 closing the door, 1 positioning, 2 electrical connection

6.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center.
6.2 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
7. TECHNICAL DATA
Dimension of the recess
Height
1030 mm
Width
560 mm
Depth
550 mm
Rising Time
12 h
Voltage
230-240 V
Frequency
50 Hz
The technical information are situated in
the rating plate on the internal left side
of the appliance and in the energy label.
8. INSTALLATION
8.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.
The appliance shall have the
plug accessible after installation.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
Ambient temperature
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
8.2 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
ENGLISH
29