GPK UPPERTONE - Manual (Page 4)

2"-3"Gap
Figure 9
D. Rowing Lever Assembly (Figure 7)
1. Cut the plastic zip ties on the Frame Legs (2) where the Rowing Levers (5) are to be inserted.
2. Insert the Rowing Levers into the Bearings (65). Secure them with Shaft Collars (32) by sliding each
Shaft Collar over the protruding Rowing Lever shaft and tightening the black set screw with the Allen
wrench. Both Rowing Levers (5) should rest against the Row Stops.
3. Insert the Rowing Adjusters (7) into the Rowing Levers (5).
4. Thread the black Wing Handles (12) into the Rowing Levers (5). These handles are used to adjust the
height of the Rowing Adjusters (7).
5. Insert the Tri-Pin system into the row adjuster as shown in Figure 8, and then screw in the Bumper (40)
with the Nut (9) and put in the Plug (37).
E. Cable Installation (Figures 9, 10, & 11)
Note: When you have finished installing the cable, as shown in Figure 8 there should be a gap of 2" to
3" between the truck arms and the stop. If you do not have this gap, the cable is incorrectly installed.
See Figure 8.
1. Attach the Hook Bolt (33) to the
top of the Frame Post (3) using the
two nuts that were on the Hook
Bolt. Slide the Hook Bolt halfway
through the Frame Post. Thread
Figure 10
9
10
8
7
6
3
5
2 “front” sticker
1 Hook Bolt (33)
4
Curl Arm (30)
Shaft
Collar (32)
Rowing
Lever (5)
Row
Stop
Wing
Handle
(12)
Rowing
Adjuster
(7)
Flanged
Bearing
(65)
Bumper (40)
Nut (9)
Plug (37)
Figure 7 Figure 8
Tri-Pin
System