Braun 530s-4 Series 5 - Manual (Page 8)

9
• Switch the shaver on (cordless) and rinse
the shaver head under hot running water.
You may use liquid soap without abrasive
substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next, switch off the shaver, press the foil
release buttons (3) to remove the shaver foil
(1) and cutter block (2). Then leave the
disassembled shaving parts to dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil onto the long hair trimmer
and shaver foil.
The following quick cleaning is another
alternative cleaning method:
• Press the foil release buttons (3) to lift
the shaver foil (do not remove the foil
completely). Switch on the shaver for
approx. 5–10 seconds so that the shaved
stubbles can fall out.
• Switch off the shaver. Remove the shaver
foil and tap it out on a flat surface. Using a
brush, clean the inner area of the shaver
head. However, do not clean the shaver foil
nor the cutter block with the brush as this
will damage them.
Keeping your shaver in top
shape
Replacing the shaver foil and cutter block /
Reset
To maintain the appliance performing like
new, replace the shaver foil (1) and cutter
block (2), when the replacement symbol (8)
lights up (after about 18 months) or when
worn.
The replacement symbol will remind you
during the next 7 shaves to replace the
shaving parts. Then the shaver will
automatically reset the display.
After you have replaced the shaving parts
(foil and cutter block), press the on/off switch
(6) for at least 5 seconds to reset the counter.
While doing so, the replacement light blinks
and goes off when the reset is complete.
The manual reset can be done at any time.
Accessories
Available at your dealer or Braun Service
Centers:
Shaver foil and cutter block: 51S
Environmental notice
This appliance contains rechargeable
batteries. To protect the environment,
do not dispose of the appliance in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Center or appropriate collection sites.
Subject to change without notice.
For electric specifications, see printing on the
special cord set.
99252273_570s_NA_S6-32.indd 9 99252273_570s_NA_S6-32.indd 9 10.02.11 13:16 10.02.11 13:16