ICY DOCK MB673SPF-B - Manual (Page 5)

English
PUSH
<C> The cooling fan is removable when it is not needed. After the cooling fan is removed the FAN FAIL system and alarm will not transmit any
signals. ( When the cooling fan is removed the Fan Fail Alarm will be disabled.)
ɀ Backplane instructions: Please connect 2 x 4-pin molex from the main power source to fully enable the device.
1. HDD failure will indicate red only when the signals are transmitted by HOST (Please refer to the HDD-fail Signal)
2. The testing condition were at the surrounding temperature at 25°C
3. ICY DOCK reserves the right to change or to upgrade any technical specifications without prior notice.
4. ICY DOCK will not be liable for any software, hardware, and/or stored data that may be become damaged or dysfunctional through the usage
of our product. ICY DOCK will only be responsible for repairing and servicing its own product.
5. Due to specification differences between SATA I and SATA II hard drives, the LED will only work with SATA II hard drives. To enable the
enclosure’s LED with SATA I hard drives, please refer to Note 4.
6. To allow the enclosure’s LED to work with SATA I hard drives, you will need an optional HDD Access cable. Please connect the Access signal
pins 1, 2, 3 provided on the backplane of the enclosure to the respective Host Port’s Access signal pins. Please refer to your host port’s
instruction manual to locate its Access signal pins.
7. To determine if SATA II hard drives have built in HDD Access signal, please refer to your HDD manufacture specifications.
8. To perform hot-swap function, the host side must also support hot-swap.
9. For any further inquiries about ICY DOCK product or related product information, please visit: www.icydock.com
Note ǽ
4