Swanstone MF-1W - Installation - Manual (Page 10)

2. Attach Wall Mounting Plate
22aa.. A Attttaacchh W Waallll M Moouunnttiinngg P Pllaattee ttoo FFrraam meedd
W Waallllss
1. Locate the rough position of the laundry tub and
then locate the wall studs. The mounting plate must
be attached using at least three screws.
If only two screws can be used, install cross blocking
(2” x 6”) between the studs and then attach the wall
mounting plate. Again, for double sinks install cross
blocking (2” x 6”) between the studs to add extra support
for the wall mounting plate and the sink.
2. Determine the comfortable working height of the top
of the sink. This height may vary depending on your
application; however, a typical dimension is 32” up
from the floor. Use a level to mark a line 1” below
the desired height on the wall.
Note: Trial fit the wall mounting plate to the laundry tub.
If the mounting plate is too long, break off the left
side of the wall mounting plate by snapping it
along the plate’s scored ridge.
LT-024
LT-023
31”
LT-022
LT-021
The Swan Corporation – Swanstone 10 800-325-7008
Installation Procedure