dbx DriveRack PA+ - Manual (Page 15)

3.5 Navigating the Crossover Section
Freq- Out to 20 kHz
Type -BW6-24,LR12,24
Gain- Inf to 20dB
Low
High Pass Low Pass High Pass Low Pass High Pass XOVER
To edit the parameters of the Crossover used in a selected preset, simply use the following procedure. From preset mode,
press the XOVER button. Once you have reached the Crossover module, Navigate through the Pages of the selected Crossover
module by pressing the "Next Page" or "Prev Page" buttons successively until arriving at the desired Page.
Freq- 20 Hz to Out
Type- BW6-24,LR12,24
Low
Freq- Out to 20 kHz
Type- BW6-24,LR12,24
Gain- Inf to 20dB
Mid
Freq- 20 Hz to Out
Type- BW6-24,LR12,24
Mid
Freq- Out to 20 kHz
Type- BW6-24,LR12,24
Gain- Inf to 20dB
High
Type (BS,BW,L-R)
Frequency
Slope
SSub >
Type (BS,BW,L-R)
Frequency
Slope
<SSub
Successive presses of the Data Wheel will toggle between
effect parameters within the currently selected page.
XOVER
3.6 Navigating the AFS (Advanced Feedback Suppression) Section
The PREV PG and NEXT PG
buttons scroll through
the pages of the selected module.
Navigating the Advanced Feedback Supression (AFS) Section
AFS On/Off
AFS Clear Mode - Fixed/Live
Type- Speech, Low,Med and High
Number of Fixed filters 0-12 Live filter Lift - On/Off
Lift After - 0-60
FEEDBACK
FEEDBACK
From preset mode, press the FEEDBACK button. Pressing the Data Wheel will select the parameter to be edited.
<PREV PG NEXT PG>
Successive presses of the Data Wheel will toggle between
parameters within the currently selected page.
Section 3
Editing Functions
11
DriveRack
®
PA+