Braun 7681-5377 Silk-épil 7 - Manual (Page 15)

15
sensitive directly after epilation, avoid
using irritating substances such as deo-
dorants with alcohol.
5 Facial epilation
For removing any unwanted hair from
the face or other sensitive areas, use the
precision cap (9) as an optional attachment
to be placed on the epilation head (2).
For the first few usages, we recommend
that you select speed setting «I» in order to
get used to the epilation sensation in those
sensitive areas.
Prior to epilation, we recommend cleaning
the skin with alcohol to promote good
hygiene.
When epilating the face, stretch the skin
with one hand and slowly guide the
epilator with your other hand the direction
of the switch.
Overheating protection
As a safety feature to avoid the unlikely
event of the appliance overheating, it may
happen that the red low charge light shines
permanently for 8 seconds and then the
appliance turns off automatically. In this case,
turn the switch back to the position «0» and
let the appliance cool down.
6 Cleaning the epilation head
Regular cleaning ensures better perform-
ance.
a Brush cleaning:
Remove the cap and brush it out.
Thoroughly clean the tweezers from the
rear side of the epilator head with the
brush dipped into alcohol. While doing so,
turn the tweezer element manually. This
cleaning method ensures best hygienic
conditions for the epilation head.
b Cleaning under running water:
After each wet usage, clean the appliance
under running water.
Remove the cap. Hold the appliance with
the epilation head under hot running water.
Then press the release button (6) to remove
the epilation head.
Thoroughly shake both, the epilation
head and the appliance to make sure that
remaining water can drip out. Leave both
parts to dry. Before reattaching, make sure
that they are completely dry.
B Using the shaver head
attachment
a OptiTrim comb
b Shaver foil
c Trimmer
d Release buttons
e Trim/shave selector
f Cutter
block
g Shaver head base
Shaving
• Put on the shaver head attachment (10) by
clicking it in.
• Pressing one of the lock keys, turn the
switch clockwise to setting «II».
• Make sure the trim/shave selector (e) is in
the « » position.
• Use the shaver head attachment on dry
skin only.
• For best results, always make sure that
both, the shaver foil (b) and the trimmer (c)
are in contact with the skin (A). Keeping
your skin stretched (B), slowly move the
appliance against the direction of hair
growth. The trimmer first raises all long
hairs and cuts them off. Then the flexible
foil follows to smooth away any stubble.
• When shaving or trimming in sensitive
areas, make sure that you always keep
your skin stretched to avoid injuries.
92291809_SE7681_7281_MN_S6-76.indd 15 92291809_SE7681_7281_MN_S6-76.indd 15 29.10.12 16:06 29.10.12 16:06