Cleaning troubleshooting – AEG EWA5210 User Manual
Page 14
14
GB
GB
GB
1. Before cleaning, always unplug the
appliance. Never rinse or immerse
the kettle or base unit in water. Just
wipe with a damp cloth, using no
abrasive detergents. Occasionally
rinse out the kettle with clean water.
3. Decalcifying is recommended
regularly, depending on water
hardness. Fill the kettle with water
and decalcifyer according to
decalcifyer product instructions.
Do not boil the solution as it could
foam over. Afterwards, rinse kettle
thorougly with fresh water.
2. To clean the mesh fi lter, grab the
strainer insert and lift out.
Cleaning the heating plate –
superfi cial spots of rust may appear
on the heating plate. Remove with a
stainless steel cleaning agent.
Cleaning
Troubleshooting
Problem
Possible cause
Solution
The appliance switches off before boiling.
Too much lime scale at the heating element of
the kettle.
Run the decalcifying procedure.
The appliance does not switch off .
Close lid until it locks.
Insert the mesh fi lter correcttly.
The appliance cannot be switched on.
After operating with little or no water, the
appliance has not cooled down suffi ently.
Allow to cool a short time and try again.
ELX12789_Florence_WaterKettle_AEG_5lang.indd 14
2010-05-03 14:25:24