Braun 760cc-4 Series 7 - Manual (Page 13)

13
« » shaver is clean
« » short economical cleaning required
« » normal level of cleaning required
« » high intensive cleaning required
If the station selects one of the required cleaning
programs, it will not start unless you press the
start button
4
. For best shaving results, we
recommend cleaning after each shave.
Whilst cleaning is in progress, the respective
cleaning program indicator will blink. Each
cleaning program consists of several cycles,
where cleaning fl uid is fl ushed through the
shaver head and a heat drying process dries
the shaver. Depending on the program selected
the total cleaning time will range from 32 to 43
minutes.
The cleaning programs should not be inter-
rupted. Please note that whilst the shaver is
drying, the shaving head may be hot and wet.
When the program is fi nished, the blue « »
indicator will light up. Your shaver is now clean
and ready for use.
Stand-by mode
10 minutes after completing the charging or
cleaning session, the Clean&Renew station
switches to the stand-by mode: The indicators
of the Clean&Renew station turn off.
Shaver display
The shaver display
z
shows the charge status
of the battery. During charging or when using the
shaver, the respective green charge status will
blink. When the battery is fully charged the green
charge status will light up continously, provided
the shaver is switched on or connected to an
electrical outlet.
Stand-by mode
(Shaver is switched off but connected to the
mains)
Some minutes after completing the charging, the
shaver switches to the stand-by-mode:
The display turns off.
Low charge indicator:
The red low charge indicator blinks to
indicate that the charge has dropped below
20%, provided the shaver is switched on.
The remaining battery capacity is suffi cient
for 2 to 3 shaves.
10
0
8
0
6 0
4
0
2
0
10
0
8
0
6 0
4
0
2
0
10
0
8
0
6 0
4
0
2
0
10
0
8
0
6 0
4
0
2
0
99500894_760cc_S4-102.indd 13 99500894_760cc_S4-102.indd 13 08.03.2010 11:50:29 Uhr 08.03.2010 11:50:29 Uhr