Theater-Solutions TS4ODB_TS4ODW - Manual

Listening Test
Once you have connected your speakers, turn on your system and begin playback
of material you are familiar with. Begin at low volume and increase to a comfortable
listening level. The system should sound balanced with stereo sound. if the sound is
distorted and confused, check to make sure that the speakers have been correctly
wired to your amplifier/receiver.
Attaching to a wall
Note: Failure to properly install the speaker could result in injury from falling objects.
Maintenance
Simply use a damp cloth to clean, avoid use of chemical products and polishes .
Note:
This Loudspeaker is not water-proof. Please do not submerge in water (eg.a pool or
pond), as this will void your manufacturer's warranty.
Unpacking the Speakers
Carefully unpack the speakers and retain the carton and packing materials for future
use.
Wiring the speakers
Note: Please turn off and unplug your system prior to making any connections.
To wire your system, please use good quality, speaker grade audio cable with
polarity coding (usually identified with a marking on the cable) as per the gauge
recommendations indicated below. The side of the cable that has the coding (a
ridge, or "+" marking) usually denotes the positive polarity.
Connect the positive lead of the speaker wire (indicated with a "+" ) to the Red (or
positive) speaker terminal. Connect the other speaker wire lead to the Black (or
negative) speaker terminal.
Connect the opposite end of the speaker wire to your amplifier making sure that the
polarity is preserved ("+" to "+" or Red to Red, and "-" to "-" or Black to Black ). see
diagram below
Gauge 18 16 14
Amplifier
Left Speaker
Left Right
Right Speaker
Speaker Connections
Securely attach piece#1
to the wall using fixings
that are appropriate for
the wall construction.
Screw loosely into piece #1.
Screw speaker to #4.
Slide between piece
#1 and piece #2.
Tighten screws from
Check that speaker and all
mounting parts are secure.
5
6
TS4OD
TS525OD
TS60D
TS4OD
TS525OD
TS60D
Theater Solutions Theater Solutions
TS4OD
Specifications:
• 1” Soft Dome Tweeter
• 4” Polypropylene Hybrid Cone
• 80Hz - 20kHz Frequency Response
• 8 Ohm Nominal Impedance
• 90 dB Sensitivity
• 300 Watts Max Power Per Pair
TS525OD
Specifications:
• 1” Soft Dome Tweeter
• 5.25” Polypropylene Hybrid Cone
• 75Hz - 20kHz Frequency Response
• 8 Ohm Nominal Impedance
• 91 dB Sensitivity
• 400 Watts Max Power Per Pair
TS6OD
Specifications:
• 1” Silk Dome Tweeter
• 6.5” Polypropylene Hybrid Cone
• 65Hz - 20kHz Frequency Response
• 8 Ohm Nominal Impedance
• 92 dB Sensitivity
500 Watts Max Power Per Pair
Up to 25` 40` >40`