QTECH SmartEdge 100 PPP and PPPoE - Manual (Page 17)

Configuration Tasks
3.1.4 Configure a Subscriber Record for PPP
To configure a circuit for PPP in the subscriber record, perform the tasks
described in Table 5. Enter all commands in subscriber configuration mode.
Table 5 Configure a Subscriber Record for PPP
Step Task Root Command Notes
1. Set the MTU used by PPP
for the subscriber circuit. ppp mtu
2. For subscriber sessions on
PPP multilink bundles, limit
the number of sessions
a subscriber can access
simultaneously. port-limit The maximum number of PPP
multilink sessions (links) is 8.
For descriptions of the basic tasks needed to configure a subscriber record, see
the document, Configuring Subscribers.
3.1.5 Configure an Interface for Static PPP Peer Router IP Address
Assignment
To configure an interface for static PPP peer router IP address assignment,
perform the tasks described in Table 6. Enter all commands in subscriber
configuration mode.
Table 6 Configure an Interface for Static PPP Peer Router IP Address Assignment
Task Root Command Notes
Configures a static IP address that the
system can proved to the static PPP peer
devices during the establishment of PPP
sessions. ppp ipcp peer-addre
ss ip-address should
belong to the same subnet
as the interface.
The peer ip-address
assignment is only for
PPP links (not for PPP
subscriber sessions),
and is applicable to only
T1 cards; such as, the
Channelized-DS3 cards.
For descriptions of the basic tasks needed to configure a subscriber record,
see Configuring Subscribers.
3.1.6 Configure MLPPP on ATM PVCs
To configure MLPPP using PPP-encapsulated ATM PVCs, perform the tasks
described in Table 7. Enter all commands in global configuration mode.
13 64/1543-CRA 119 1170/1 Uen K | 2012-12-04