Installation, Start-up and use, Positioning and connection – Hotpoint Ariston Doppia Porta ETM 17321 V O3 User Manual

Page 19: Starting the appliance, Setting the temperature, Pure wind

Advertising
background image

GB

19

Installation

! Before placing your new appliance into operation please read

these operating instructions carefully. They contain important
information for safe use, for installation and for care of the
appliance.
! Please keep these operating instructions for future reference.

Pass them on to possible new owners of the appliance.

Positioning and connection

Positioning

1. Place the appliance in a well-ventilated humidity-free room.
2. Do not obstruct the rear fan grills. The compressor and

condenser give off heat and require good ventilation to
operate correctly and save energy.

3. Leave a space of at least 10 cm between the top part of

the appliance and any furniture above it, and at least 5 cm
between the sides and any furniture/side walls.

4. Ensure the appliance is away from any sources of heat

(direct sunlight, electric stove, etc.).

5. In order to maintain the correct distance between the

appliance and the wall behind it, fit the spacers supplied in
the installation kit, following the instructions provided.

Levelling

1. Install the appliance on a level and rigid floor.
2. If the floor is not perfectly horizontal, adjust the refrigerator

by tightening or loosening the front feet.

Electrical connections

After the appliance has been transported, carefully place it
vertically and wait at least 3 hours before connecting it to the
electricity mains. Before inserting the plug into the electrical
socket ensure the following:

• The appliance is earthed and the plug is compliant with the

law.

• The socket can withstand the maximum power of the

appliance, which is indicated on the data plate located on
the bottom left side of the fridge (e.g. 150 W).

• The voltage must be in the range between the values indicated

on the data plate located on the bottom left side (e.g. 220-
240V).

• The socket is compatible with the plug of the appliance. If

the socket is incompatible with the plug, ask an authorised
technician to replace it (see Assistance). Do not use extension

cords or multiple sockets.

! Once the appliance has been installed, the power supply

cable and the electrical socket must be easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by

authorised technicians only (see Assistance).
! The manufacturer declines any liability should these
safety measures not be observed.

Start-up and use

Starting the appliance

! Before starting the appliance, follow the installation
instructions (see Installation).
!
Before connecting the appliance, clean the compartments

and accessories well with lukewarm water and bicarbonate.

1. Insert the plug into the socket and ensure that the internal

light illuminates.

2. Turn the TEMPERATURE ADJUSTMENT knob to an average

value. After a few hours you will be able to put food in the
refrigerator.

Setting the temperature

The temperature inside the refrigerator compartment
automatically adjusts itself according to the position of the
TEMPERATURE ADJUSTMENT knob.
1 = warmest

5 = coldest

We recommend, however, a medium position.
The cooling section of the refrigerator is located inside the
back wall of the refrigerator compartment for increased space
and improved aesthetics. During operation, the back wall will
be covered in frost or water droplets depending on whether
the compressor is operating or paused. Do not worry, the
refrigerator is functioning normally.
If the TEMPERATURE ADJUSTMENT knob has been set
on high values with large quantities of food and with a high
ambient temperature, the appliance can operate continuously,
resulting in excessive frost formation and excessive energy
consumption: compensate for this by shifting the knob towards
lower values (defrosting will occur automatically). In static
appliances, the air circulates in a natural way: the colder air
tends to move downwards as it is heavier. The food should be
stored as follows:

Food

Arrangement inside the

refrigerator

Fresh fish and meat

Above the fruit and vegetable bins

Fresh cheese

Above the fruit and vegetable bins

Cooked food

On any shelf

Salami, loaves of bread,

chocolate

On any shelf

Fruit and vegetables

In the fruit and vegetable

compartment bins

Eggs

On the shelf provided

Butter and margarine

On the shelf provided

Bottles, drinks, milk

On the shelves provided

PURE WIND *

It is recognizable due to the presence of the mechanism on the
top part of the refrigerator compartment (see diagram).

A

B

B

B

A

*

Varies by number and/or position, available only on certain

models.

Advertising