Braun EP100 Exact Power - Manual (Page 8)

8
English
Our products are designed to meet the highest standards of quality,
functionality and design. We hope you enjoy your new Braun appliance.
Warning
• Keep the appliance dry.
• Do not wind the cord around the appliance.
• For safety reasons, periodically check the cord for damage and replace
it if necessary.
Description
Technical specifications
Power supply: 100 – 240 V 2 / 50 or 60 Hz (automatic adaptation)
Wattage: 4
Charging your beard trimmer for cordless operation
• For the first 3 chargings: Connect the trimmer to the mains with the on/
off switch on position «0» and charge it for at least 4 hours. The pilot
light indicates that the trimmer is connected to the mains. When the
rechargeable battery is fully charged, the pilot light will noticeably
weaken. If later on, the pilot light comes on again, this indicates that the
trimmer is being recharged to maintain its full capacity.
• Once the trimmer is completely charged, use it without the cord until
discharged.
• Then recharge to full capacity again (subsequent charges will take
about 1 hour).
• A full charge will give up to 30 minutes of cordless trimming depending
on your beard. However, the maximum capacity will only be reached
after several charging/discharging cycles.
1a Small distance comb (trimming
beard and short hair)
1b Large distance comb (cutting hair)
2 Pivoting twin cutter system
a beard trimmer
b contour trimmer
c release buttons
3 Speed selector
4 On/off switch
with beard length selector
5 Memory switch
(for 6 beard length settings)
6 Pilot light
5601196_EP100_MN Seite 8 Dienstag, 18. Januar 2005 10:54 10