Start-up and use – Hotpoint Ariston CG64SG1 (W) I /HA User Manual

Page 18

Advertising
background image

18

GB

Using the hob

Lighting the burners

For each BURNER knob there is a complete ring
showing the strength of the flame for the relevant
burner.
To light one of the burners on the hob:
1. Bring a flame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an
anticlockwise direction so that it is pointing to the
maximum flame setting E.
3. Adjust the intensity of the flame to the desired level
by turning the BURNER knob in an anticlockwise
direction. This may be the minimum setting C, the
maximum setting E or any position in between the two.

If the appliance is fitted with an electronic lighting

device* (see fi gure), press the
ignition button, marked with

the symbol

1

, then hold the

BURNER knob down and turn
it in an anticlockwise direction,
towards the maximum flame
setting, until the burner is lit.The
burner may be extinguished

when the knob is released. If this occurs, repeat the
operation, holding the knob down for a longer period of
time.

! If the flame is accidentally extinguished, switch off the
burner and wait for at least 1 minute before attempting
to relight it.

If the appliance is equipped with a flame failure
safety device*, press and hold the BURNER knob for
approximately 2-3 seconds to keep the flame alight
and to activate the device.

To switch the burner off, turn the knob until it reaches
the stop position

•.

Practical advice on using the burners

For the burners to work in the most efficient way
possible and to save on the amount of gas consumed, it
is recommended that only pans that have a lid and a flat
base are used. They should also be suited to the size of
the burner.

Start-up and use

To identify the type of burner, please refer to the
diagrams contained in the “Burner and nozzle
specifications”.

! On the models supplied with a reducer shelf,
remember that this should be used only for the auxiliary
burner when you use casserole dishes with a diameter
under 12 cm.

Using the oven

! Before operating the product, remove all plastic film
from the sides of the appliance.

! The first time you use your appliance, heat the empty
oven with its door closed at its maximum temperature
for at least half an hour. Ensure that the room is well
ventilated before switching the oven off and opening
the oven door. The appliance may emit a slightly
unpleasant odour caused by protective substances
used during the manufacturing process burning away.

! Never put objects directly on the bottom of the oven;
this will avoid the enamel coating being damaged.
Only use position 1 in the oven when cooking with the
rotisserie spit.

Lighting the oven

To light the oven burner, bring a flame or gas lighter
close to opening F (see fi gure) and press the OVEN

control knob while turning it in
an anticlockwise direction until
it reaches the MAX position.

If the appliance is fitted with
an electronic lighting device*
(see figure), press the ignition
button, marked with the symbol

1

, then hold the OVEN control knob and turn it in an

anticlockwise direction, towards the MAX position, until
the burner is lit. If, after 15 seconds, the burner is still
not alight, release the knob, open the oven door and
wait for at least 1 minute before trying to light it again.
If there is no electricity the burner may be lit using a
flame or a lighter, as described above.

! The oven is fitted with a safety device and it is
therefore necessary to hold the OVEN control knob
down for approximately 6 seconds.

*

Only available in certain models.

F

Burner

ř Cookware diameter (cm)

Fast (R)

24 - 26

Semi Fast (S)

16 - 20

Auxiliary (A)

10 - 14

Advertising
This manual is related to the following products: