Ocean Optics HPX-2000 - Manual (Page 10)

1: Setup
2 000-10000-080-02-201207
Unpacking the HPX-2000
►
Procedure
1. Unpack your lamp assembly carefully. Although the lamp is rigidly mounted, dropping this
instrument can cause permanent damage.
2. Inspect the outside of the instrument and make sure that there is no damage. Do not use the
instrument if damage is present. Contact your dealer for repair or replacement information, if
necessary.
3. Use this instrument in a clean laboratory environment (see Operating Environment ).
Contents
Your HPX-2000 package should contain the following:
 HPX-2000 High-Power Light Source
 Power cord
 UV safety goggles
 One IC-DB15-2 interface cable for shutter operation
 This manual
Connecting the Fiber Optic Cable
►
Procedure
To connect the fiber optic cable to the HPX-2000,
1. Locate the cap on the front of the HPX-2000.
2. Lift the cap on the front of the HPX-2000 to expose the SMA connector.
3. Connect the fiber optic cable to the SMA connector.