Changing the bulbs – Ocean Optics Vivo User Manual

Page 12

Advertising
background image

1: Setup and Operation

4

000-vivo-110-02-201208

2. To fasten the SMA-barrel, tighten the screw shown below with a hexagonal socket screw key SW

2.5.

Changing the Bulbs

Caution

Bulbs must be changed as a pair (two face-to-face bulbs are considered to be a pair).

Do not over-tighten the screws. The plastic screws could be damaged and the stud
screws could damage the bulbs if they are tightened too much.

►

Procedure

1. Before changing the bulbs switch off the power and disconnect the power plug.

2. Unfasten the lamps by dismounting the top plate. To do this, unscrew the 4 plastic screws on the

top plate (shown in figure below).

Advertising