Ocean Optics LIBS2500plus - Manual (Page 19)

166-00000-000-02-0110 9
Chapter 2
Installing the LIBS System
Overview
In general, installing the LIBS2500plus involves the following steps:
► Procedure
1. Unpack and set up the LIBS2500plus components. See Hardware Set-up .
2. Install the OOILIBSplus software on the PC you intend to use with your LIBS2500plus System,
and then restart the PC. See Software Installation .
3. Connect the cables to the appropriate connectors on the LIBS2500plus equipment (see Hardware
Cabling ).
4. Test that the LIBS2500plus System is operational (see System Start-up ).
Note
Consult the instructions provided with the LIBS Imaging Module and the laser being
used for complete installation and operation instructions for those products. General
guidelines are provided in this manual, but may not cover all the information that you
need to install and operate these components of your LIBS System.
Hardware Set-up
Set up your LIBS2500plus System in the configuration shown in the following figure. Do NOT connect
any of the cables until you have installed the OOILIBSplus Software.