Appendix a – Ocean Optics S2000 User Manual
Page 101
Interrupt Request Settings for the ADC1000 and PC2000
To change the IRQ settings on the ADC1000 and PC2000, see the bank of switches on the A/D board: The IRQ
may be changed via the last 3 switches. The following matrix defines the different IRQ settings by switch positions
7, 8, and 9. In the default setting, the IRQ is set to 7. Other combinations for IRQ settings are below. After you
have changed the switches, reinstall the card and change the software settings to match the hardware settings. (See
pages 19-22 for instructions.) The gray block indicates the position of the switch.
Appendix A
- 101 -
Switch #
7
8
9
ON
OFF
Switch #
7
8
9
ON
OFF
Switch #
7
8
9
ON
OFF
Switch #
7
8
9
ON
OFF
Switch #
7
8
9
ON
OFF
Switch #
7
8
9
ON
OFF
Switch #
7
8
9
ON
OFF
Interrupt Request 7 (Default Setting)
Interrupt Request 5
Interrupt Request 3
sw itch is in the on, upw ard position =
Interrupt Request 9
Interrupt Request 10
Interrupt Request 11
Interrupt Request 4