Ocean Optics EMBED2000+ - Manual (Page 6)

EMBED2000+ Data Sheet
6 029-20000-005-05-201305
All signals required for communication via the SPI bus and control of the spectrometer are available
on a 16-pin Hirose FFC 1mm connector. The pinout and signal descriptions are provided in the table
below. The part number of the Hirose connector is: FH12-16S-1SH(55)
Pin # Signal Name Description
1 GND System ground
2 3.3V System power
3 FIFO_RST FIFO Chip Select
4 X_RESET FPGA async. global reset
5 FIFO_RST Acquisition source
6 PIXEL_RDY Pixel data ready
7 MISO SPI data from slave
8 MOSI SPI data to slave
9 SPI_CLK SPI clock
10 SPI_CS FPGA chip select
11 ADT_CS Temperature IC chip select
12 E2_CS Calibration EEPROM select
13 Trigger Acquisition event trigger
14 ContStrobe Free running clock
15 SingleStrobe Integration synchronous clock
16 NC Manufacturing use only