Ocean Optics LLS Series LED - Manual (Page 3)

LLS Series Installation and Operation Instructions
300-00000-011-01-201301 3
Part Number Wavelength FWHM
Min. Power
Coupled into a 600
µ
m .22NA Fiber
Max. Drive
Current CW
Max. Drive
Current
Pulsed
Max. Duty
Cycle in
Pulsed
Mode
LLS-Neutral
White 4100K
CCT
N/A
1mw (measured at
550nm)
1000mA 2000mA 50%
LLS-Warm
White 3000K
CCT
N/A
1mw (measured at
550nm)
1000mA 2000mA 50%
Controls
The LLS Light source features two control knobs on the front. The knob on the right controls the input
mode. The switch turned fully clockwise is the continuous mode, “off” is the middle position and fully
counter-clockwise is pulse mode. Remember that an external trigger is required for pulsing. This can
be accomplished via a cable connected to your electronics, or through an optional USB controller.
The left knob controls intensity. Turn clockwise for maximum intensity. The intensity control will
work in both pulse and continuous modes.
Front View of LLS Light Source