SENA Rhio232 User Manual
Page 32
32
⑥
The Monitor Power Stop button is clicked on.
CSettingDlg::OnBnClickedButtonMonitorPwrStop()
⑦
The Set Power Stop button is clicked on.
CSettingDlg::OnBnClickedButtonSetPwrStop()
⑧
The Monitor Enable State of the Port button is clicked on.
CSettingDlg::OnBnClickedButtonMonitorEnable()
⑨
The Enable Port button is clicked on.
CSettingDlg::OnBnClickedButtonSetEnable()
⑩
The Monitor ADC Input button is clicked on.
CSettingDlg::OnBnClickedButtonMonitorInput()
⑪
The Set ADC Input button is clicked on.
CSettingDlg::OnBnClickedButtonSetInput()
⑫
The Check Delay/Pulse State button is clicked on.
CSettingDlg::OnBnClickedButtonMonitorOutput2()
⑬
The Set Delay/Pulse button is clicked on.
CSettingDlg::OnBnClickedButtonSetOutput2()
⑭
The Check Macro Setting button is clicked on.
CSettingDlg::OnBnClickedButtonMonitorOutput()
⑮
The Set Macro button is clicked on.
CSettingDlg::OnBnClickedButtonSetOutput()
３) When an event occurs in a Rhio device:
CWEB_IO_TESTDlg::OnUpdateState(WPARAM wParam,
LPARAM lParam)
①
A port ON/OFF event occurs.
m_rhGetOnOffData (SOnOffStateData &sOnOffData)
②
Events other than a port ON/OFF occur.
CSettingDlg::OnReceive(WPARAM wParam, LPARAM lParam)