SENA Parani-MSP100 User Manual
Page 27
Advertising
27
5. Reset
6. Reboot
7. Change password
8. System Log
q. Quit
>> 4
--- Serial Port Configuration ---
AT command interface: Disabled
115200 bps 8-N-1 hardware
1. Baudrate
2. Character Size
3. Parity
4. Stopbit
5. Flow Control
6. AT command
q. Quit
>>
-
Logout the console (q.Quit)
-
To apply changes to the configuration, turn off the Parani-MSP100.
-
Users will need to move the Switch on the left side of Parani-MSP100 to right side
position for Data communication.
-
Turn on the Parani-MSP100, and then Parani-MSP100 will start operating in RS232
mode.
Please note that if you need to make use of data communication via RS232 port, you
will not need to configure Network settings.
ii) Set the Parani-SD configuration
- Make connection from Parani-SD to the Parani -MSP100.
Advertising