Billet Specialties Premium Tru Trac Serpentine System - Pontiac - Manual (Page 5)

www.billetspecialties.com www.billetspecialties.com
9
Figure 4: Install Alternator Bracket
[A] Attach to the driver side of motor as shown using one 1-1/16" stand off on the top stud
and finger tighten.
[B] Follow by installing the special 1-1/16" duplex stand off on the smaller 5/16” stud below.
This standoff is identified by one large threaded hole (3/8”) and a smaller hole on the other
side (5/16”).
[C] The larger hole (3/8") will face outward, tighten both spacers firmly.
At this time tighten the four 5/16-18 x 1-1/4” 12 pt. cap screws installed in Figure 2 (21 ft/lbs).
Figure 3: Install Power Steering Bracket
For kits without power steering continue to Figure 4.
Locate the power steering bracket and the alternator bracket.
Apply anti-seize to the two 5/16-18 x 7/8” socket head cap screws.
[A] Attach the power steering bracket to the back of the alternator bracket with the two
5/16-18 x 7/8" socket head cap screws. Tighten firmly.
A A C
B