Billet Specialties V-Trac Pulley System - Big Block Chevy - Manual (Page 4)

If you do not have power steering proceed to Step 2.
STEP 1: Apply anti-seize to the threads of the two 5/16-24 x 3” socket head cap
screws. Place power steering pump and pulley onto bracket and thread the two
5/16” socket head cap screws with 5/16” lock washers through pump into
bracket and tighten firmly.
STEP 2: Apply anti-seize to the threads of four 8mm-1.25 x 25mm 12pt. ARP cap
screws. Align bridge bracket mount holes with the four spacer nuts. Install the four
8mm 12pt. ARP cap screws and tighten firmly.
Figure 4: Install Power Steering Pump & Bridge Bracket
7
Install water pump onto studs (make sure O-rings are still seated).
Apply anti-seize to exposed stud threads. Thread the four 3” spacer nuts onto the
studs with the hex end out. Tighten all spacer nuts firmly at this time.
Also tighten lower 7/16” cap screws on alternator bracket or power steering
bracket.
TECH LINE: 708-588-0505 FAX 708-588-7181 www.billetspecialties.com
Figure 3: Install Water Pump