Mustang Motorcycle Seats Two-Piece Vintage Seat with Driver Backrest - Harley-Davidson VRSCA & VRSCB, No Studs User Manual
Page 3
Enjoy the Comfort of your new Mustang Seat!
Mounting of Mustang Seat continued
Step 5
Step 6
Step 4
Mustang Solo Seat
4. Install the supplied 6 mm x 35 mm long bolts through the motorcycle's hinge mounts then nylon
washers and locknuts.
5. Tighten with a 10 mm wrench. DO NOT OVER TIGHTEN NUTS.
6. Slowly close seat making sure pin lock aligb=ngs with hole in frame to complete the installation process.
Mounting Suggestions: Harley-Davidson® V-Rod: VRSCA & VRSCB Two-Piece Seat
continued from page 2)
page 3
Updated 10/14/10 AA
These steps are guidelines to help you install your new Mustang product. If you need further assistance, please call us at
800-243-1392, Monday through Friday 9:00 - 5:30 Eastern, or send an email to [email protected], or visit
our website at www.mustangseats.com.
For care and maintenance of our seats, please go to our website under "Support".
Refers to part numbers: 75885, 79335