Mustang Motorcycle Seats Cyclone Frame Mounting Plate 2004-06 & 2010-2013 Sportsters with 2.1, 3.3 & 4.5 gallon tanks - Manual (Page 2)

Page 2 of 3
Install Frame Mounting Plate with Cyclone Solo seat onto motorcycle
1. Remove stock seat from motorcycle.
2. Prepare motorcycle frame to receive the frame mounting plate by removing the stock 5/16 torx fastener
located at the front end of the rear fender. Use a wrench on the ½” bolt under the fender and a #40 torx
driver to remove this fastener. It is not used in the installation of the Mustang products.
3. Slide the nose bracket of the completed frame mounting plate and solo seat assembly under the gas tank
mount.
4. Align the threaded insert at the center rear of the frame mounting plate with the 5/16 hole in the frame
from which the torx fastener was removed.
5. From under the rear fender, insert the ¼‐20 x 1 ¼” long hex head bolt and screw it securely into the
threaded insert in the frame mounting plate.
Mounting Suggestions Harley‐Davidson® Sportster 2004‐06 & 2010 Models Only Cyclone Solo Seat &
Frame Mounting Plate continued from page 1
1/4‐20 x 1‐1/4” bolt