Pro Series 51145 51 Receiver - Manual

Installation Instructions
JEEP WRANGLER
Part Numbers:
51145
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 5/8, 3/4, Torque wrench
Drill Bits: NONE
Hitch requires 5/8” pin & clip
1. Remove existing bolt from frame/bumper attachment (one from each side of vehicle).
2. If equipped, remove tow hooks and return to customer.
3. Raise hitch into position as shown. Replace bolt removed in step one with 7/16-14 x 1-1/2” bolts or M12 x 1.75 x 40mm
bolts as shown. Bolts required vary by vehicle. Install remaining fasteners as shown.
Rev. A 8-3-09 51145N Sheet 1 of 3 z 2009 Cequent Performance Products
Tighten all 7/16 GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Tighten all ½ GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Tighten all M12 CL 8.8 fasteners with torque wrench to 68 Lb.-Ft. (91 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 51145F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
400 (181 Kg) 4000 (1814 Kg)
Weight Carrying
Ball Mount
N/A N/A Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV 5, SUV 7
Form: F205 Rev A 5-6-05
1
2
Conical Toothed Washer 7/16 Qty. (2) 4
Handle Nut assembly ½-13 Qty. (2) 7 Hex Bolt - 7/16-14 x 1.50 Gr5 Qty. (2) 3
Lock washer 1/2 Qty. (2) 6 Conical Toothed Washer 1/2 Qty. (2) 2
Hex Bolt - ½-13 x 1.75 Gr5 Qty. (2) 5 Hex Bolt - M12 x 1.75 x 40mm CL 8.8 Qty. (2) 1
5
6
7
3
4
Bumper
Fasteners Typical
Both Sides
Exhaust
Frame
Existing Weldnut
Varies by Vehicle
Existing Access
Hole