Draw-Tite 63138 BIKE CARRIERS - Manual

ITEM: 63138
DESCRIPTION: Q-Slot 4 Bike Rack
Assembly Instructions:
1.
Attach the (2) side tubes (short) to 2” shank assembly using the 5/16-18 x 2.25” carriage bolts and 5/16” lock nuts provided.
2. Attach the vertical center tube to 2” shank assembly using one 5/16-18 x 2.25” carriage bolt and 5/16” lock nut provided
Important Note: Tighten lock nuts so the support tubes still swing freely – see figure 2. There must be 1 – 2 threads of bolt
past end of lock nuts.
3. Rotate side tubes to the horizontal position as illustrated. Align holes in plates and side tubes and secure tubes in position
with bail pins as shown (Figure 1).
4. Rotate center tube to the vertical position as illustrated. Align holes in u-shaped bracket and tube and secure in position with
bail pin as shown.
DESCRIPTION QTY. DESCRIPTION QTY.
2” Shank Assembly 1 Support Tube Assembly 1
Side Tube - Short 2 1-1/4” Shank 1
Center Tube - Long 1 3/8-16 x 2.0 Carriage Bolt 2
5/16-18 x 2.25 Carriage Bolt 3 3/8-16 Hex Lock Nut 2
5/16-18 Hex Lock Nut 3 1/2-13 Anti-Rattle Pin 1
Bail Pin 3 1/2" Flat Washer 1
5/8-11 Anti-Rattle Pin 1 Wrench 3/4 , 1-1/16 1
5/8" Flat Washer 1 Spring Clip 2
LH Wheel Cradle Assembly 4 Frame Hook Assembly – Long 2
RH Wheel Cradle Assembly 4 Frame Hook Assembly – Short 2
Kit Contents:
TOOLS REQUIRED:
½” Wrench
9/16 Wrench
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
63138N Rev D 6-29-12
FIGURE 2.
Important:
1 – 2 Threads
Minimum
Side Tube (Short)
(2) Places
Center Tube (Long)
5/16” Carriage Bolt
(3) Places
Bail Pin
Bail Pin
2” Shank Assembly
Pin Clip
5/8” Anti-Rattle Pin
5/16” Lock Nut
(3) Places
FIGURE 1.
5/8” Flat Washer
2” Hitch
Page 1 of 15
Printed in China
Label side up